Ruijie RG-NBS5000Series Switches Release Notes, SWITCH_3.0(1)B11P54

Release Date: Jul,29, 2021

Contents

This document includes the following sections:

n Basic Information

n Hardware Supported

n New Features

n Resolved Issues

n Related Documentation

nUpgrade Files

n Upgrade Tips

Basic Information

Table 1 lists the basic information of the current release.

Table 1 Basic Information of the Current Release

HardwareSupported

Table 2 shows the hardware supported by the SWITCH_3.0(1)B11P54.

Table 2 Hardware Models

NewFeatures

1.  Gateway-targeted ARP SpoofingPrevention

2.  IP+MAC Binding

3.  IP Source Guard

4. Information Center

5. eWeb Supports Syslog

6. Management VLAN Supports DHCP ServerFunction

7.  eWeb Alarm and Corresponding Suggestion

8. Restore the Default Password but Keepthe Configuration

ResolvedIssues

N/A

RelatedDocumentation

n  Ruijie RG-NBS5000 Series Switches HardwareInstallation and Reference Guide
This manual introduces the functional and physical features of the RG-NBS5000series switches and provides the installation steps, hardware troubleshooting,module technical specifications, and specifications and usage guidelines forcables and connectors. 

n   Ruijie NBS Series Switches Web-Based Configuration Guide
This manual introduces eWeb and configuration steps.

Upgrade Files

Table 3 Upgrade File

UpgradeTips

The following are some tips for upgrading the RG-NBS5000 SeriesSwitches SWITCH_3.0(1)B11P54:

n During theupgrade and downgrade, pay attention to the prompt messages. If failures occur,please save the log and contact us for technical assistance.

n During theupgrade and downgrade, it is recommended you not power off or reset the system,or plug/unplug any module.

n Check theversion number after the upgrade/downgrade ineither of the following two ways:

1. Log into eWeb and check the version number in BasicInfo on the Home page.

2. Access shell via an SSH session and enter the ucishow sysinfo command.

Upgrade Steps

1.  Connect the device to a PC and configure the PC with an IP addressin network 10.44.77.10/255.255.255.0.

2.  Power on the device. After the system LED turns on, open the browserand enter 10.44.77.200 into the address bar.

3.  Log into eWeb and complete wizard configuration.

4.  Navigate to System > Upgrade > Local Upgrade,click Browse, select an upgrade file (e.g., SWITCH_3.0(1)B11P54_NBS5000_08181817.tar.gz) and click Upload.

Figure 1 Local Upgrade

After upgrade finishes, log in to eWeb to check the version number.

Figure 2 Basic Info

If you forget your password, press the Reset button on thepanel for 5 seconds, and the device will be restored to factory settings.Upgrade the device with the above steps.